Splash Clip
Instructions
- Close shower curtain to determine point on wall where wall clip (A) will be applied to wall. Thoroughly clean this entire area with household rubbing alcohol to remove all traces of soap, etc. Make a small vertical mark here.
- Wall clip (A) will be installed first. Clip wall clip (A) to curtain clip (B). Remove release film from adhesive. Position vertically where tub meets wall at point determined in Step 1 and press hard against wall running pressure up and down the length of the clip to insure good adhesion. (Combining the two clips during installation of the wall clip insures that it will be straight.)
- Remove curtain clip (B) from clip (A) and close shower curtain. It will help in attaching curtain clip to curtain to hold curtain taut in closed position with a bit of masking tape or freezer tape to tub. Simply insert edge of curtain into clip and close clip securely “locking” curtain edge.
- Curtain clip (B) is now in position and is most easily clipped in wall clip (A) by starting at the top and quickly running pressure down the length of the handle.
- Splash Clip is unclipped very easily by pulling slightly on the handle or by pulling open the curtain. (It is recommended that the handle be used to avoid tearing the curtain.)